Solo-Ri Remote Indicator Scale; Unpacking; Scale Assembly; Wall Mounting The Solo-Ri Display - Detecto solo Series Owner's Manual

solo-RI REMOTE INDICATOR SCALE

Unpacking

Remove the scale base, display, hardware pack, and other components from the shipping
carton. After removing from the carton, check for any damage that may have taken place
during shipment. Keep and use the original carton and packing material for return shipment if
it should become necessary. The purchaser is responsible for filing all claims for any
damages or loss incurred during transit. Remove all plastic wrapping, foam fillers, and
cardboard material from the scale base, display, and other components. You should have the
following components:
(1) Scale Base with attached Display
(1) Wall Bracket "A" (includes four (4) feet
for desk or table mounting)
(1) Wall Bracket "B"
(1) Hardware Pack, containing:
(2) M3.0x25 Screws and plastic
wall anchors
M3.0x25 Screw
Plastic Wall Anchor
(4) Carpet Feet

Scale Assembly

The solo-RI does not require any assembly. After installing batteries, the scale is ready for
operation.

Wall Mounting the solo-RI Display

The solo-RI display has a 7.25 ft (2.2 m) cable to allow it to be placed at a convenient
position away from the scale base. A bracket is included to mount the display on a wall, or
the bracket (and included feet) can be used to place it on a desk or table for easy viewing.
1. Choose the location to mount the display on the wall. The location should be free of
temperature extremes and water. It should be where the display can be easily viewed, not
subject to direct sunlight, and where the keypad is within easy reach of the operator.
2. Make certain the structure and mounting hardware are of sufficient strength to support the
display. The mounting bracket should be securely fastened to the wall so that it cannot
break loose from the mounting surface.
3. Referring to Figure No. 5 and using Wall Bracket "B" for a template, place the bracket
against the wall (the notch (arrow) pointing up) and mark the holes to use to mount it.
Remove the bracket and drill two (2) 13/64 in (5 mm) holes in the wall for the mounting
wall anchors.
4. Insert the wall anchors in the wall until they are flush with the wall.
0044-0391-0M Rev F solo Series Owner's Manual 7