Attach Handle To Vacuum - Bissell Momentum/PowerTrak 82G7 Series User Manual

A
The only tool you'll need to assemble your
™
vacuum cleaner is a Phillips screwdriver.

Attach handle to vacuum

1.
2. Stand the vacuum upright and from the
3.
st 'n
ap
™
se
4.
5. Insert 2 of the screws provided (3 total)
rved
se
nd
6. Attach the hose and cord clip by snapping
r
Clip
7. Attach the lower hose clip by snapping it
e
nd
e
w w w . b i s s e l l . c a
DJ68-00375P (EN)-0.1.indd 5
ssembly
Locate the handle and cord wrap. Remove
the screw packet taped to the handle.
rear of the unit, slide the base, of the handle
firmly into the grooves at the top of the
vacuum body.
IMPORTANT – before inserting the screws
into the handle, slide the cord wrap into the
handle.
Ensure that the handle and cord wrap are
firmly fit to the vacuum body. If there are
any gaps, continue to push firmly until the
handle and cord wrap are flush.
into the existing holes, attaching the cord
wrap and handle to the body of the vacuum.
Tighten securely with a screwdriver.
it into the handle of the unit. Secure it by
inserting the screw provided.
into place and twisting to the right.
2.
7.
Hose Clip
CAUTION:
Do not plug in your
vacuum cleaner until
you are familiar with
all instructions and
operating procedures.
3.
6.
WARNING:
Plastic film can be
dangerous. To avoid
danger of suffocation,
keep away from babies
and children.
1 - 8 0 0 - 2 6 3 - 2 5 3 5
5
09. 12. 03 9:16