Swann BK-326072 Manual page 26

Installation Procedure
7. Temporarily secure the soap dish with masking tape,
as shown. Remove tape after approximately two
hours. Do not place anything on the soap dish for at
least 24 hours.
Corner Molding (Optional)
Installing the corner molding is optional. If the panels
were scribed and cut to create a tight-fitting corner, then
the corner molding can be eliminated. If, however, there
are gaps between the front/rear panel, the corner
molding should be installed. Either option, if done
properly, is acceptable.
If the optional soap dish was installed, cut one piece of
molding to fit above the soap dish and one for below the
soap dish.
NOTE: The silicone adhesive required for the
installation of the corner molding is the same as used for
the installation of the Swanstone wall panels. This kit
contains enough adhesive for both the wall panels and
the corner molding.
The Swan Corporation – Swanstone
1. Measure and cut the corner moldings to length. If
the optional soap dish was installed, cut one piece
of molding to fit above the soap dish and one for
below the soap dish.
BK-SD-005
2. Dry fit the corner molding.
26
BK-CM-001c
K-CM-002
800-325-7008