Swann BK-326072 Manual page 25

Soap Dish Installation (Optional)
The soap dish is a corner mount design. The soap
dishes can be stacked in one corner or placed in
opposite corners.
1. Select a desirable height for mounting one or both
soap dishes. A height of at least 43" from the
shower floor to the soap dish is recommended.
43"
2. After marking the height, draw a 4" level-line on both
walls. These lines will be used to align the top
edges of the soap dish.
800-325-7008
3. Dry fit the soap dish prior to applying silicone. If the
wall is not exactly 90 degrees square, it will be
necessary to sand one side in order to achieve
proper fit. Use a course grit (60 grit) sandpaper.
4. Apply a generous amount of silicone to the edge of
the soap dish. If the corner molding was not
installed, apply silicone as shown in lower drawing.
BK-SD-001
5. Align the soap dish with the level-lines and press it
into place.
6. Hold the soap dish securely in place and wipe off
excess silicone. You will want a uniform bead on
both top and bottom.
BK-SD-002
25
Installation Procedure
The Swan Corporation – Swanstone
K-SD-003b
BK-SD-004b