Table of Contents
Advertisement
Installation Procedure
3. Cut two smaller strips of cardboard and place one of
them against the seat surface. Tape the cardboard
in place.
4. Place the other cardboard strip against the face of
the seat. Tape the cardboard in place.
5. Place a small piece of tape next to the rounded
edge.
The Swan Corporation – Swanstone
6. Carefully remove the template.
7. If the back wall is less than 59" wide, the panel will
need to be cut to fit the opening. Use a piece of
cardboard to create a template for the side opposite
the bench seat. Make sure the cardboard is laying
flat on top of the shower base and up against the
front wall. Scribe (mark) the cardboard template, as
shown. This will ensure the back panel fits the exact
contour of the front wall. Cutting the back panel to
precisely fit the wall is not necessary if the corner
molding supplied in the kit is used. This corner
molding will cover gaps up to 1/2".
16
K-Scribe-01
800-325-7008
Advertisement
Table of Contents
