Swann BK-326072 Manual page 22

Shower base, wall panel, bench seat, and recessed shampoo shelf
Table of Contents

Advertisement

Installation Procedure
2. Place two braces against each front and rear wall
and place two braces against the rear panel of the
seat area.
3. Install (wedge) four horizontal braces (eight total)
against the side wall braces.
The Swan Corporation – Swanstone
4. Insert small blocks between the front to rear panel
braces and the back panel braces. These will apply
pressure to the back panel to hold it in place.
K-T -002
5. Remove the braces after 24 hours.
Recessed Shampoo Shelf
Install the recessed shampoo shelf after the braces are
removed.
Select a desirable location for mounting the recessed
shampoo shelf. A stud finder may be used to assist in
locating an area which will place the unit between studs.
The depth of recessed shampoo shelf (3-1/4") will not
permit any obstruction in the wall (light fixture, electrical
wiring, plumbing, etc.).
K-T -003
Marking the exact location for the recessed shampoo
shelf is a critical step. If the location is marked wrong and
the back panel is cut, the panel cannot be patched or
repaired.
22
IMPORTANT NOTICE
IMPORTANT NOTICE
K-T -004
800-325-7008

Advertisement

Table of Contents
loading

Table of Contents