Back Panel - Swann BK-326072 Manual

WARNING
Fumes Hazard
The fumes from the sealants and
solvents used by the installer can be
harmful if used in an unventilated room.
Always work in a well-ventilated area.
2. Clean the backs of each panel with denatured
alcohol or another non oil-based cleaning solvent.
IMPORTANT NOTICE
Do not use oil-based cleaners, such as mineral spirits, to
clean the panels. The oil in the cleaner will prevent the
panel from adhering properly to the wall.
3. Apply the silicone in 1-1/4" diameter dots 8 to 10
inches apart over the surface of the panel. Follow
the silicone manufacturers' instructions and note all
ventilation and installation precautions.
800-325-7008
4. Place the seat, with the rounded edges facing out,
onto the silicone. Make sure the seat is correctly
positioned and place weight on top of the seat to
hold it firmly in place.
K-PI-001

Back Panel

1. Make a template for the bench seat cutout in the
back wall. The side of the box from the kit can be
used to make this template.
2. Cut out the corner of the template larger than the
seat area. Make sure the cardboard is square
against the wall and shower base.
15
Installation Procedure
The Swan Corporation – Swanstone
K- S-002b
K- P-001