Troubleshooting - Bissell Pet Hair Eraser 66T6 Series User Manual

T
roubleshooting
Vacuum cleaner won't run
Possible causes
1. Vacuum cleaner is not plugged in
2. Power button is not pressed down
Vacuum cleaner won't pick up or low suction
Possible causes
1. Tools, flex hose and/or telescoping
extension wand are blocked
2. Filters are dirty
3. Dirt cup is full
4. Swivel hose not securely attached to suction opening
5. Crack or hole in flex hose
6. Air flow regulator or variable suction power
control is set to open or minimum setting
7.
Wide Pet TurboBrush is clogged or debris is
wraped around brush
Visible dust escaping from vacuum
Possible causes
1. Dirt cup is full
2. Filters missing or installed incorrectly
3. Filters are dirty
4. Flex hose is blocked
5. Swivel hose not securely attached to suction opening
6. Crack or hole in flex hose
other maintenance or service not included in the manual should be performed by an
Thank you for selecting a bISSEll product.
contact bISSEll consumer Services at 1-800-237-7691.
w w w . b i s s e l l . c o m w w w . b i s s e l l . c o m
authorized service representative.
Please do not return this product to the store.
for any questions or concerns, please
WaRnInG:
To reduce the risk of electric shock,
turn power off and disconnect
plug from electrical outlet before
performing maintenance or

troubleshooting.

Remedies
1. Check electrical plug
2. Press power button down
Remedies
1. Remove each part and check for blockages
2. Check and clean or replace all filters
3. Empty dirt cup
4. Make sure swivel hose is locked into
suction opening
5. Check hose and replace if needed
6. Change to closed or maximum setting
7. Check Wide Pet TurboBrush, see page 12
Remedies
1. Empty dirt cup
2. Check all filters for correct installation
3. Check and clean or replace all filters
4. Remove hose and check for
blockages
5. Make sure swivel hose is locked into
suction opening
6. Check hose and replace if needed
8 0 0 . 2 3 7 . 7 6 9 1
13 16