Download Print this page
Cadet CEH005P Owner's Manual

Cadet CEH005P Owner's Manual

Hide thumbs Also See for CEH005P:

Advertisement

Quick Links

The CEH Industrial Unit Heater
TOOLS REQUIRED:
Appropriate Fasteners
Wire Strippers
WARNING
Turn the electrical power off at the electrical panel board (circuit breaker or fuse box) and lock
or tag the panel board door to prevent someone from turning on power while you are working
on the heater. Failure to do so could result in serious electrical shock, burns, or possible death.
1. Read all instructions before installing or using this heater.
2. Read all information labels. Verify that the electrical supply
wires are the same voltage as the heater.
3. All electrical work and materials must comply with the
National Electric Code (NEC), the Occupational Safety and
Health Act (OSHA), and all state and local codes.
4. Connect the grounding screw provided in the wall can
to the supply ground wire.
5. If you need to install a new circuit or need additional wiring
information, consult a qualified electrician.
6. Protect electrical supply from kinks, sharp objects, oil,
grease, hot surfaces or chemicals.
7.
WARNING
Overheating or fire may occur. DO NOT install the heater
in a floor, in the ceiling, below a towel bar, behind a door, or
anywhere the air discharge may be blocked in any manner.
8.
WARNING
Fire or explosion may occur. DO NOT install heater in any
area where combustible vapors, gases, gasoline, liquids, or
excessive lint or dust are present. A heater has hot and arcing
or sparking parts inside.
9.
WARNING
DO NOT install where heater is likely to get wet. Do not
use outdoors.
www.cadetco.com
OWNER'S GUIDE
Features & Benefits
Model: CEH005P
Recommended for elevations under 7500 feet
Straight Screwdriver
Strain Relief Connector
IMPORTANT INSTRUCTIONS
SAVE THESE INSTRUCTIONS
Tel: 360-693-2505
P.O. Box 1675
Commercial grade high temperature
manual reset
High mass, tubular element for longer life
Fan delay eliminates cold draft on startup
and disperses residual heat on shutdown
Rugged die formed construction for durability
Wire single or three phase to suit the application
Vertical or horizontal delivery
5 Year Warranty
Crescent Wrench
Phillips Screwdriver
10.
WARNING
Burn Hazard. This heater is hot when in use. To avoid burns,
do not let bare skin touch hot surfaces. Use extreme caution
when any heater is used by or near children or invalids, and
whenever the heater is left operating and unattended.
11.
WARNING
Risk of Electrical Shock. DO NOT install the heater directly
above bathtub or sink. DO NOT install in shower stall area
(Manufacturer recommends a minimum 2 foot clearance).
12.
WARNING
Risk of Electrical Shock. Connect grounding lead to grounding
screw provided. Keep all foreign objects out of heater.
13.
WARNING
Risk of Electrical Shock. Never place a switch where it can
be reached from the tub or shower enclosure.
14.
WARNING
Risk of Fire. Do not block heater. Heater must be kept clear of
all obstructions: Keep combustible materials, such as furniture,
pillows, bedding, papers, clothes, etc. and curtains at least 3 feet
from the front of the heater and 6 inches above and on both sides.
15.
WARNING
Risk of Electrical Shock. Do not operate any heater after it
malfunctions. Disconnect power at service panel and have
heater inspected by a reputable electrician before reusing.
16.
WARNING
Use this heater only as described in this manual. Any other use
not recommended by the manufacturer may cause fire, electric
shock, or injury to persons.
Vancouver, WA
1
98668-1675

Advertisement

loading

Summary of Contents for Cadet CEH005P

  • Page 1 Rugged die formed construction for durability • Wire single or three phase to suit the application • Vertical or horizontal delivery • 5 Year Warranty • Model: CEH005P Recommended for elevations under 7500 feet TOOLS REQUIRED: Appropriate Fasteners Straight Screwdriver Crescent Wrench • •...
  • Page 2: Installation Instructions

    INFORMATION. THERMOSTAT: For single-phase only, a line voltage thermostat is required for operation. For three-phase, a two-stage or modulating thermostat is required. A Cadet wall thermostat is recommended for ultimate control and comfort. Horizontal Delivery Vertical Delivery...
  • Page 3: Wiring Instructions

    Installation Instructions WARNING! Risk of Electrical Mounting the CEH Unit Heater Shock. Turn off Horizontal Discharge Vertical Discharge all power at the (See Figure 2 for minimum clearances) (See Figure 5 for minimum clearances) electrical panel 1. Mounting with rod from ceiling or super-structure: 1.
  • Page 4 Wiring Instructions CAUTION – READ THESE INSTRUCTIONS CAREFULLY WHEN USING ALUMINUM WIRING 1. Carefully strip insulation from aluminum conductors and coat ends of conductors with suitable corrosion inhibitor (“Pentrox A” or equivalent). 2. Wire brush aluminum surface, removing corrosion; re-coat with corrosion inhibitor. 3.
  • Page 5: Wiring Diagram

    P1 and P2 are connected with a jumper. NOTE: For single phase operation, terminal L2 should be left unconnected. CEH005P Operation & Maintenance How to operate your heater Maintenance Turn your built-in or wall thermostat to the desired setting. The 1.
  • Page 6: Parts List

    Warranty Maintenance: For safer operation and to prolong the life of the heater, it is 8. IN THE EVENT CADET ELECTS TO REPLACE ANY PART OF YOUR CADET necessary to follow the maintenance instructions included with each heater. PRODUCT, THE REPLACEMENT PARTS ARE SUBJECT TO THE SAME Failure to properly maintain the heater will result in the warranty being voided.