Table of Contents
Advertisement
Quick Links
The CEH Industrial Unit Heater
Tools Required:
Appropriate Fasteners
Straight Screwdriver
Crescent Wrench
Strain Relief Connector
Phillips Screwdriver
Wire Strippers
WARNING
Turn the electrical power off at the electrical
panel board (circuit breaker or fuse box) and lock
or tag the panel board door to prevent someone from
turning on power while you are working on the
heater. Failure to do so could result in serious
electrical shock, burns, or possible death.
1.
2.
Verify that the electrical supply
wires are the same voltage as the heater.
3.
4.
5.
6.
TEL: 360-693-2505 Fax: 360-694-8668 P.O. Box 1675 Vancouver, WA 98668-1675
OWNER'S GUIDE
Features & Benefits
Models:
CEH-003M
CEH-003MB
CEH-003P
CEH-003PB
IMPORTANT INSTRUCTIONS
SAVE THESE INSTRUCTIONS
CEH-003RB
CEH-003R
CEH-003SB
CEH-005M
CEH-005MB
7.
WARNING
Overheating or fire may occur. DO NOT
8.
WARNING
Fire or explosion may occur. DO NOT
9.
WARNING
Burn Hazard.
10.
WARNING
Risk of Electrical Shock.
11.
WARNING
Risk of Fire. Do not block heater.
CEH-005P
CEH-005PB
CEH-005R
CEH-005SB
Advertisement
Table of Contents
Related Manuals for Cadet CEH-003M
Summary of Contents for Cadet CEH-003M
- Page 1 Verify that the electrical supply wires are the same voltage as the heater. SAVE THESE INSTRUCTIONS TEL: 360-693-2505 Fax: 360-694-8668 P.O. Box 1675 Vancouver, WA 98668-1675 Features & Benefits Models: CEH-003RB CEH-005P CEH-003M CEH-003R CEH-005PB CEH-003MB CEH-003SB CEH-005R CEH-003P CEH-005M...
-
Page 2: Installation Instructions
READ ALL INSTRUC- TIONS AND SAFETY INFORMATION. PLACEMENT: THERMOSTAT: A line voltage OR low voltage thermostat is required for operation. Horizontal Delivery WARNING! When working with electricity, turn the electrical power off at the Figure 1. electrical panel board and lock or tag the circuit breaker door. -
Page 3: Operation And Maintenance
Installation Instructions Vertical Delivery Figure 5. Figure 4. Figure 6. General Safety Information Mounting the CEH Unit Heater CAUTION: THE CEILING OR WALL MOUNTING STRUCTURE AND ANCHORING PROVISIONS MUST BE OF SUFFICIENT STRENGTH TO SUPPORT THE COMBINED WEIGHT OF THE HEATER AND MOUNTING BRACKETS Vertical Discharge BACK... -
Page 4: Wiring Instructions
CAUTION: TO AVOID ELECTRICAL SHOCK, BE SURE ELECTRICITY IS TURNED OFF AT ELECTRICAL PANEL BOARD BEFORE WIRING. ALL WIRING MUST BE DONE IN ACCORDANCE WITH LOCAL CODES AND THE HEATER MUST BE GROUNDED AS A PRECAUTION AGAINST POSSIBLE ELECTRIC SHOCK. IN ABSENCE OF LOCAL CODES, FIELD WIRING TO THE UNIT SHALL COMPLY WITH CURRENT PROVI- SIONS OF THE AMERICAN NATIONAL ELECTRICAL CODE OR YOUR NATIONAL ELECTRICAL CODE, AS APPLICABLE. -
Page 5: Wiring Diagrams
Control Voltage Wiring NOTE: NOTE: BACK Figure 13. Wiring Instructions FRONT Line Voltage Control Models (Singe Phase): Wiring Diagrams Figure 14. FRONT... - Page 6 Wiring Diagrams...
- Page 7 Wiring Diagrams Parts List...
-
Page 8: Troubleshooting Chart
WRITTEN WARRANTIES OR ANY IMPLIED WARRANTY. These warranties give you specific legal rights, and you may also have other rights which vary from state to state. Cadet neither assumes, nor authorizes anyone to assume for it, any other obligation or liability in connection with these electric heaters or any part of such heaters.