Safety Rules - Northern Lights TECHNICOLD OM-NI Operator's Manual

IMPORTANT SAFETY INSTRUCTIONS.
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
IN THIS MANUAL, PRIOR TO THE INSTALLATION
OF ANY GENERATOR SET OR ACCESSORY. KEEP
THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Recognize Safety Symbols and
Instructions
In addition to the information found in
this section, this operator's manual uses
three different signal words to outline
potential dangers of a specific nature.
DANGER
DANGER indicates a hazardous situation which, if
!
not avoided, will result in death or serious injury.
WARNING WARNING indicates a hazardous situation which, if
!
not avoided, could result in death or serious injury.
CAUTION indicates a hazardous situation which,
CAUTION
!
if not avoided, could result in minor or moderate
injury.
Follow All Safety Instructions
Carefully read and understand all safety messages in this
manual and on your machine's safety signs. Keep signs
in good and clean condition. Replace missing or damaged
signs. Be sure new equipment components and repair
parts include the current safety signs. For replacement
signs, proper placement of safety signs or clarification on
any safety issue, consult your the Technicold factory .
There may be additional safety information contained
on parts and components from outside suppliers that is
not reproduced in this manual. Consult the suppliers for
additional safety information.
Learn how to operate the machine and how to use the
controls properly. Only trained personnel should operate
machines, or work on or around them.
Keep you machine in proper working condition.
UNAUTHORIZED MODIFICATIONS TO THE
MACHINERY MAY IMPAIR ITS FUNCTION AND
SAFETY PARAMETERS.

Safety Rules

SAFETY AND HAZARD WARNINGS
CAUTION
!
IMPORTANT
DO NOT REMOVE THE FRONT COVER WITHOUT
FIRST DISCONNECTING THE 3 CABLES/CONNEC-
TORS ON THE REAR OF THE DISPLAY. For ease of
access to the cables, remove the top cover and left side panel.
WARNING
!
Sharp Edges
Equipment may have sharp edges. Wear gloves and
use safe handling practices when installing and servicing
the equipment.
WARNING
!
Lifting
Equipment is heavy. To prevent personal injury, do not lift
equipment if beyond your physical ability. Use safety equip-
ment when moving and installing the unit.
WARNING
!
Pinch Hazard
Use caution when handling equipment. Use protective gloves
and do not place hands under the equipment when setting it
down.
DANGER
!
Electric Shock
High voltages present. Do not power up unless all electrical
connections are made, and covers closed. To reduce the risk
of shock, remove power before servicing.
DANGER
!
Ignition Protection/Explosion Hazard
The equipment is not ignition protected per 33 CFR 183.410.
Do not install in an area that can be exposed to flammable gas.
CAUTION
!
Burn Hazard
Hot Parts! Do not operate with the covers removed.
OM-NI 2/20
7