Table of Contents
Advertisement
All manuals and user guides at all-guides.com
A
/D
RMING
ISARMING
Disarming Group 'D' Block Omit
Note 1
if display shows INVALID CODE YES/NO
press the 'Yes' or 'No' key and re-enter your
access code.
Note 2
The 9610 control panel has a special user
access code known as 'Block Omit'. By
entering this code it allows all the circuits
allocated to Group 'D' to be armed or
disarmed, while any of the three other groups
is armed. The code will only operate providing
the system has been armed using another
group.
Note 3
Only circuits allocated to Group 'D' are disarmed. If any other detectors not within Group 'D' are
violated, a full alarm condition will be initiated.
Rearming Group 'D' Block Omit
B
O
G
D
LOCK
MIT
ROUP
Enter the premises
via the prescribed
Entry Route
Entry tone starts
Key-in your 'Block
Omit Code' at the
nearest keypad
ENTER CODE
****
BLOCK OMITTED
00:01 MON 01 JAN
00:01 MON 01 JAN
****
Key-in your Block Omit
Code
ENTER CODE
****
LEAVE AREA
Leave the premises via the
prescribed exit route. The system
will automatically re-arm the
circuits in Group 'D' on expiry of
the exit timer or closing of the final
door, or pressing the exit
terminate button.
(Refer also to Notes 3 & 4 Page 3)
6
7
Advertisement
Table of Contents
