Table of Contents
Advertisement
All manuals and user guides at all-guides.com
D
19
Call alarm company engineer to check system.
CALL ENGINEER
System is unable to reset due to a fault existing. Check as
CANNOT RESET
necessary or call engineer.
User has exceeded the programmed exit time or a fault exists
EXIT FAULT
with the detection on exit route, check as necessary or call
engineer.
A smoke or heat detector fitted to the system has been acti-
FIRE
vated.
Incorrect user code has been entered, re-try up to 4 times before
INVALID CODE
tamper alarm will occur.
Stand-by battery is low, call alarm company engineer to check
LOW BATTERY
system.
240v main supply to control panel lost, check fuse board or spur
MAINS FAILED
outlet. Call engineer to check if required.
PERSONAL
A personal attack button fitted to the system has been acti-
ATTACK
vated.
The logging printer has been disconnected, de-selected or has
PRINTER FAULT
run out of paper. Call engineer to check system.
Fault within control panel, call engineer to check system.
SYSTEM FAULT
System has successfully reset, all wiring and circuits are
SYSTEM RESET
correct.
System anti-tamper switch opened or damage to wiring has
TAMPER FAULT
occured. Call engineer to check system.
Telephone line fault, call alarm company engineer to
TELEPHONE
check system.
FAILED
A zone which the engineer has programmed for 14 day test has
ZONE TEST FAILED
been violated. Call engineer to check system.
A zone programmed as 24 hour alarm has been violated,
24 HOUR ALARM
display will show description. Check system as necessary.
20
M
ISPLAY
ESSAGES
Advertisement
Table of Contents
