Digigram IQOYA TALK User Manual page 2

Important Safety and Warranty Information
Follow these instructions and keep them in a safe place! Keep in mind that damages due to failure to observe the
instructions contained in this manual are not covered by warranty.
GENERAL WARNINGS
Use the codec only under the specified environmental conditions. Avoid installation in extreme weather conditions
and exposure to direct sunlight or heating equipment. Avoid moist or humid locations.
Do not open the codec, as there are no user-serviceable components inside. Opening the cabinet may present a
shock hazard, and any modification to the product will void your warranty. Refer all servicing to qualified service
personnel.
Power supply
The device is to be connected to a power supply as specified in this manual and marked on the equipment.
Make sure the power cord is not damaged. Do not route the power cord where it may be crushed, bent,
exposed to heat or damaged in any way.
BATTERY
This device contains a lithium-ion battery. When shipped to the customer for the first time, the battery is delivered
in shipping mode. To enter "use" mode, the battery must first be placed in the external charger for a few minutes.
The equipment is supplied with replaceable batteries. If used with an incompatible battery, an explosion may occur.
CLEANING
Clean only with a soft, dry cloth. If necessary, after disconnecting the unit's cables, wipe it with a soft cloth
dampened with mild soapy water, then with a fresh cloth with clean water. Wipe dry immediately with a dry cloth.
NEVER use benzene, aerosol cleaners, thinner, alcohol or any other volatile cleaning agent. Do not use abrasive
cleaners, which may damage the finish of metal or other parts.
rd
CONNECTING 3 PARTY EQUIPMENT
This codec can provide high voltages on the inputs, so the broadcasting equipment must be suitable. Digigram
declines all responsibility for any damage to equipment connected to the codec.
RADIO FREQUENCY (RF) SAFETY INFORMATION:
Radio frequency (RF) energy from cellular devices can interact with certain electronic devices and cause
electromagnetic interference (EMI). To meet the requirements for compliance with exposure to radio frequencies,
follow all regulations regarding the use of radio equipment.
2