Wheel Assignment; Copy Scanner - Flash 384A User Manual

13 193
14 209
15 225
16 241
17 257
18 273
19 289
20 305
21 321
22 337
23 353
Please refer to your individual fixture's
manual for DMX addressing instructions.
The table above refers to a standard 9
dipswitch binary configurable device.

WHEEL ASSIGNMENT

Because not all intelligent lighting fixtures
are alike or share the same control
attributes, the DMX-240A allows the user
to assign the wheel the correct pan and
tilt channel for every individual fixture
including 16 bit channel assignments. It
also allows the user to re-assign physical
faders to fixture DMX channels so that the
user can combine or unify control of similar
or the same attributes across different
types of fixtures.
———⬤———
Action:
1) press and hold the PROGRAM button
until the led blinks
2) Press and hold FINE & MODE buttons
together
3) times to access the channel assignment
mode. The assign led will light. The wheel
can be reassigned to output on a different
dmx channel.
3) press a SCANNER button that represents
the fixture you would like to set the pan &
tilt
384A DMX CONTROLLER 384ch 2019 • Art No F9000383
1, 7, 8
1, 5, 7, 8
1, 6, 7, 8
1, 5, 6, 7, 8
1, 9
1, 5, 9
1, 6, 9
1, 5, 6, 9
1, 7, 9
1, 5, 7, 9
1, 6, 7, 9
4) Use the BANKUP/DOWN buttons to
select pan/tilt
Notes:
All wheels can be reassigned to output on a
different DMX channel.
Press AUTO/DEL&MODE buttons together
to delete the channel assignment mode.
———⬤———
Action:
5) Press the TAP/DISPLAY button to switch
pages
6) Press and hold MODE button, then
press the SCENES buttons to select the
DMXchannel. AII LEDs will blink.
7) Press and hold FINE & MODE buttons to
exit
Notes:
You can re-assign the DMX channel to all
controller fader channels.
———⬤———
Review wheel assignment or reverse
Action: (Reverse Review)
1) Press and hold FINE & MODE buttons
together to access the wheel assignment
mode
2) press a SCANNER button to select a
scanner
3) Press and hold FINE & MODE buttons
together (2) times to exit
———⬤———
Action: (wheel assignment Review)
1) Press and hold FINE & mode buttons
together (2) times to access the channel
reverse mode
2) press a SCANNER button to select a
scanner
3) Press and hold FINE & MODE buttons to
exit

COPY SCANNER

Example: Copying Scanner 1 into Scanner 2