Flash 384A User Manual page 14

User Manual •Instrukcja Obsługi
1 )Press and hold the MIDI/REC button for
about 3 seconds.
2) Select the MIDI control channel (1~16) via
the BANK UP/DOWN buttons to set.
3) Press and hold the MIDI/REC button for
3 seconds to save settings.
4) To release MIDI control, press any other
button except the BANK buttons during
step 2.
Notes:
This is the Channel that the controller will
receive MIDI note commands.
MIDI NOTE FUNCTION (TURN ON/OFF)
00 to 07 Scenes 1-8 in BANK 1
08 to 15 Scenes 1-8 in BANK 2
16 to 23 Scenes 1-8 in BANK 3
24 to 31 Scenes 1-8 in BANK 4
32 to 39 Scenes 1-8 in BANK 5
40 to 47 Scenes 1-8 in BANK 6
48 to 55 Scenes 1-8 in BANK 7
56 to 63 Scenes 1-8 in BANK 8
64 to 71 Scenes 1-8 in BANK 9
72 to 79 Scenes 1-8 in BANK 10
80 to 87 Scenes 1-8 in BANK 11
88 to 95 Scenes 1-8 in BANK 12
96 to 103 Scenes 1-8 in BANK 13
104 to 111 Scenes 1-8 in BANK 14
112 to 119 Scenes 1-8 in BANK 15
120 Chase 1
121 Chase 2
122 Chase 3
123 Chase 4
124 Chase 5
125 Chase 6
126 BLACKOUT
3.8 Data Transfer
It is possible to transfer the programs
stored in one DMX-240A controller to
another. Connect from the DMX output
of the programmed controller to the DMX
input of the other.
Action:
1) Source unit: Turn unit Off, press and hold
SCANNER buttons 2, 3 and SCENE button 1
then turn unit back On.
2) Destination unit: Turn unit Off, press
and hold SCANNER buttons 8, 9 and
SCENE button 2 then turn unit back On.
3) Both units are now ready to transmit
and receive. Press SCENE buttons 7 & 8
simult aneously on Source unit to begin
transmission.
Notes:
The display should show TR ANSMIT, this
indicates it is ready to transmit data.
The display should show RECEIVE,
this indicates it is ready to receive data
transmission.