Table of Contents
Advertisement
1.3. Package Contents
•
Hotplate-Stirrer / Hotplate / Stirrer Unit
•
UK Power Cord
•
EU Power Cord
•
EU to Swiss Adapter
•
Stir Bar (40 x 8 mm) for Hotplate-Stirrer /Stirrer units
•
Quick Start Guide
1.4. Installation
Upon receiving the VWR Hotplate-Stirrer / Hotplate / Stirrer check to ensure that no damage has occurred during
shipment. It is important that any damage that occurred in transport is detected at the time of unpacking. If you do
find such damage, the carrier must be notified immediately.
After unpacking, place the Hotplate-Stirrer / Hotplate / Stirrer on a level bench or table, away from explosive
vapors. Ensure that the surface on which the unit is placed will withstand typical heat produced by the unit and
place the unit a minimum of 15 cm from vertical surfaces. Do not position the equipment such that it is difficult to
disconnect the power cord during use. Always place the unit on a sturdy work surface.
The Hotplate-Stirrer / Hotplate / Stirrer is supplied with an EU to Swiss adapter, as well as EU and UK power cords
that are inserted into the IEC connector on the back of the unit first, and should be plugged into a properly
grounded outlet. If the cord supplied does not meet your needs, please use an approved power cord that has
ratings equal or exceeding those of the originally provided cord and that complies with the local/national regulations
of the country in which the equipment is to be used. Replacement of the plug must be made by a qualified
electrician.
4
vwr.com I Instruction Manual VWR
EURO TO SWISS ADAPTER
Step 1. Align the Swiss plug adaptor with the unit's
Euro style cord.
Step 2. Firmly connect the Swiss plug adaptor to the
power cord.
Note - The connection between the adaptor and the
power cord will be permanent.
®
Advanced Hotplate-Stirrers
Advertisement
Table of Contents
