Technical Troubleshooting Guide - TEFAL HOME CHEF CY601832 User Manual

TECHNICAL TROUBLESHOOTING GUIDE

Problem
Unable to open because of
pressure in the cooking pot.
Unable to open lid
Pressure in the pot is fully
released but the float valve is
stuck because it is too dirty,
and therefore unable to fall.
Hot pot with steam inside.
The sealing gasket was not
properly installed.
The float valve is stuck
Unable to close lid
because it is too dirty, and
therefore unable to fall.
Direction at which lid was
closed is incorrect.
Rice : water ratio is incorrect.
Food is uncooked.
No electricity from the power
grid.
Sealing gasket is broken.
Steam leakage from lid Residue in the sealing gasket.
The sealing gasket was not
properly installed.
58
Possible reasons Solutions
Press and hold the pressure
release button to remove the
pressure inside the cooking pot.
a. Press and hold the pressure
release button to remove
the pressure inside the
cooking pot. Then let the
appliance cool down for
at least 2 hours and then
press the external part of
the float valve – Fig. 23.
b. For next use, please clean
and wipe the float valve.
Wait for the pot to be cool.
Install the sealing gasket
properly.
a. Press the external part of
the float valve (when the
lid is cold) – Fig. 23.
b. For next use, please clean
and wipe the float valve.
Close lid in the correct
direction according to the
instruction manual.
Use the required rice : water
ratio.
Check the electric circuit.
Send to repair and
maintenance department.
Clean and remove the
residue.
Install the sealing gasket
properly.
Problem Possible reasons
Faulty pressure control
resulted in release of pressure.
Intense release of
pressure from pressure
Pressure limit valve did not
limit valve
fall into place.
Residue in the float valve.
Continuous pressure
release from float valve
Float valve is stuck.
"E0" , "E1" displayed on
digital screen
The lid is not in the position
defined for the selected
"E2" displayed on digital
cooking mode.
screen.
Lid switch sensor does not
function.
EN
Solutions
Send to repair and
maintenance department.
Carefully rotate/press the
pressure limit valve to make
it fall into place.
Clean and remove the
residue.
Stop the appliance and
wait for the appliance to
cool down. Then clean and
wipe the float valve, before
restarting the cooking.
Send to repair and
maintenance department.
Please refer to the cooking
table to check the right
position of the lid for the
program you have selected.
Send to repair and
maintenance department.
59