Modbus - Omntec Proteus Series System Programming Manual

OEL8000III Series

15. Modbus

Modbus Settings: Used to program
settings for Modbus.
15.1)
a) Modbus Address: Unique Modbus Slave Address.
b) Register Offset: Holding register offset, typically set to 0 or 40001.
c) Enable Code: Need an enable code from OMNTEC to run this optional feature.
d) Reverse Mode: When enabled, reverses high and low registers for certain PLCs or
computer software that accepts a different Modbus format.
e) Communication Setup: Will navigate to Comm Ports setup from the previous section.
f) Print Modbus Map: Prints the current register range for enabled probes and sensors.
(See Figure
OMNTEC Mfg., Inc., 2420 Pond Road, Ronkonkoma, NY 11779
Phone (631) 981-2001 Fax (631) 981-2007 www.OMNTEC.com
File Name: DOC00007 rev1.1.docx 21 of 37 Rev Date: 12-14-2021
Programming Manual
Figure 15.1