Table of Contents
Advertisement
Command Summary
The following table lists the commands to operate the configuration utility when the dome is installed
in a SensorNet or RS-422 environment.
If you want to ...
Start the configuration utility.
Move the highlight bar on the active menu.
Select the highlighted item on the active menu.
Increase the value of the selected setting. For example, Red or
Blue white balance values.
Decrease the value of the selected field. For example, Red or
Blue white balance values.
Display the next choice for the setting. For example,
Maximum Zoom setting.
Display the previous choice for the setting. For example,
Maximum Zoom setting.
Save changes and exit the utility from any screen.
Manually activate or deactivate IR mode.
*
These commands not supported with MPLT with ADCC0200 or ADCC0300 controller. Refer to the appropriate
operator's manual for instructions.
Setting Names / Working with Passwords
When setting names or entering password information, the screen displays the available characters in
the selected languages. In these situations, the following commands are used:
If you want to ...
Move the highlight left or right in the character field.
Move the highlight up or down in the character field.
Select the highlighted character in the character field.
Move the cursor to the right of the current character in the
name or password.
Move the cursor to the left of the current character in the
name.
A–2
Use ...
Press and hold Iris Open,
press and hold a Focus
button, then press Zoom
Out*
Pan/Tilt
Focus
Zoom In
Zoom Out
Zoom In
Zoom Out
Iris Close, then Focus*
Press and hold Iris Open,
press and hold Focus
Far, then press Focus
Near*
Use ...
Pan
Tilt
Focus
Zoom In
Zoom Out
SpeedDome Ultra VII Day/Night Operator's Manual
Advertisement
Table of Contents
