Table of Contents
Advertisement
From this screen, you can program up to eight Privacy Zones, delete all or specific Privacy Zones, or
temporarily hide all Privacy Zones. For more information see:
Topic
How Privacy Zones are Programmed
Programming Privacy Zones
Removing or Hiding Privacy Zones
Deleting Specific Privacy Zones
Deleting All Privacy Zones
Hiding Privacy Zones
How Privacy Zones are Programmed
Privacy Zones are established by selecting three points on the display image to mask. The fourth point
on the Privacy Zone is automatically generated by mirroring the longest axis between the three
selected points. Figure 4–2 illustrates how Privacy Zones are programmed.
Figure 4–2: Privacy Zone programming example
The dome's firmware prevents you from establishing a zone that is too small or too large (greater than
90-degrees pan or tilt from the starting point).
Figure 4–3 illustrates the Privacy Zone programming screen:
Figure 4–3: Privacy Zone Programming screen
4–12
+
Point 1
+
Point 4 mirrors
+
Point 2
the longest axis.
+
Point 3
NEW PRIVACY ZONE
Navigate to corner 1(2, 3)
ZOOM to Mark Corner
FOCUS to Abandon Zone
SpeedDome Ultra VII Day/Night Operator's Manual
Page Number
4–12
4–13
4–14
4–15
4–15
4–15
Advertisement
Table of Contents
