Operating The Dome Configuration Menu - American Dynamics SpeedDome Ultra VII RAS917LS Configuration

If you want to ...
Reset Dome
Auto Pan Left Limit
See Setting Left and Right Auto Pan Scan Limits on
page F–4.
Auto Pan Right Limit
See Setting Left and Right Auto Pan Scan Limits on
page F–4.
Auto Pan ON/OFF
(LED indicates Auto Pan state: ON = Auto Pan is
running.)

Operating the Dome Configuration Menu

The following table lists the commands to operate the configuration utility when the dome is installed
in a Vicon environment.
If you want to ...
Start the configuration utility.
Move the highlight bar on the active menu.
Select the highlighted item on the active menu.
Increase the value of the selected setting.
For example, Red or Blue white balance values.
Decrease the value of the selected field.
For example, Red or Blue white balance values.
Display the next choice for the setting. For example,
Maximum Zoom setting.
Display the previous choice for the setting. For
example, Maximum Zoom setting.
Vicon Protocol Command Summary
Use ...
Run/Pgm switch to PGM
Enter 97 Enter
Run/Pgm switch to PGM
Enter 98 Enter
Run/Pgm switch to PGM
Enter 99 Enter
Run/Pgm switch to RUN
A/P toggles state
Use ...
Run/Pgm switch to PGM Enter 94
Enter
Tilt Up/Down
A/P or AUX5
Pan Right (or Zoom In)
Pan Left (or Zoom Out)
Pan Right (or Zoom In)
Pan Left (or Zoom Out)
F–3