Table of Contents
Advertisement
Additional AD-UTC Commands
The following tables summarize the special commands available when using the dome in an AD-UTC
network. These commands are available when you enter the keyboard combination provided.
If you want to ...
Program selected Preset
Recall selected Preset
Start selected Pattern programming
Save Pattern programming
Run selected Pattern continuously
Resume Auto Focus mode
Resume Auto Iris mode
Rotate dome 180° from current position ("flip")
AD Up-the-Coax (UTC) Command Summary
Use ...
F
, Preset number,
(Function, Preset number (1-
96), and then Preset)
Preset number,
(Preset number, then Preset)
F
, pattern number,
(Function, pattern number (1-3),
then Shift+Preset)
F
Pattern number,
(Pattern number (1-3), then
Function)
Pattern number, then
and
(Pattern number, Shift and
Preset)
F
F
+
or
+
(Function+Focus Far or
Function+Focus Near)
F
F
+
or
+
(Function+Iris Open or
Function+Iris Close)
(Flip)
+
E–3
Advertisement
Table of Contents
