Page 7
Attach part (3,4,5,6) to part (2) using bolt (E) with hex key (G) Slide back panel (7,8) into grooves as per diagram.
Page 8
Attach part (1) to part (3,4,5,6), then insert and secure cam lock (C) to part (3,4,5,6) to lock it Attach plastic wedge (V) to part (7,8) using screw (U) with screwdriver.
Page 9
Place sticker (D) over holes as per diagram. Insert shelf support pin (H) into part(3,4,5,6).
Page 10
Place shelf (9) on top of support pin . Place plastic pivot (P) over holes as per diagram.
Page 11
Attach handle (S) to part (13,14) using handle bolt (T) with screwdriver. Attach door hinge (M,N) to part (13,14) using screw (Q) with screwdriver. Attach bolt (R) to part (13,14) with screwdriver. Insert top door hinge (M) into plastic pivot (P) on part (1), then slide the door (13) into bottom hinge (N).
Page 12
Insert top door hinge(N) into plastic pivot (P) on part (1), then slide the door (14) into the bottom hinge (M). Secure door by tightening door hinge (M) using screws (Q) with equal pressure. Insert glass holder (J) into part(4,5).