Canon BJ-200e User Manual page 74

switch is ON; the printer uses Character Set 2.
DIP switches 5, 6, 7
These switches allow you to select the following code page tables.
DIP switches
Code
5
page
437 OFF
850 OFF
850 OFF
850 ON
850 ON
860 ON
863 OFF
865 ON
To see the samples of the character sets available with each code page
table, use Canon's toll-free fax retrieval system. Call the Canon help desk
and request the fax retrieval system; then request the BJ-200e Printer
Command Summary.
DIP switch 8
When this switch is OFF, the printer performs a normal line feed. Set
this to ON if you want the printer to perform a carriage return after each
line feed.
DIP switch 9
Set this switch ON to enable Alternate Graphics Mode (AGM). In this
mode, the printer accepts high-resolution, 24-dot, all-points-addressable
(APA) graphics commands similar to those used with conventional 24-
pin printers.
DIP switch 10
When this switch is OFF, the printer allocates the entire buffer space
(50.4 KB) to the input buffer. When you are using downloaded fonts,
change this switch to ON; the printer will allocate 41 KB of buffer space
for downloaded fonts.
DIP switch 11
When this switch is OFF, the printer is in BJ-10 mode. When this switch
is ON, the printer is in Epson LQ mode.
DIP switch 12
Set this switch ON to enable automatic emulation switching mode. In
this mode, the printer detects whether the codes being sent are BJ-10
mode or Epson LQ mode. It then selects the printer control mode to
match the printer driver selected in the MS-DOS application.
6
OFF
OFF
ON
OFF
ON
ON
ON
OFF
7
OFF
ON
OFF
ON
OFF
ON
ON
OFF