Mounting Of Protector - Makita EM4350RH Instruction Manual

Connecting the lead unit
Connect the lead units from the engine (1) with the lead units from the control
lever (2) as each male and female terminals are connected.
Securing the control cable
Secure the control cable (1) to the flexible shaft by using two clamps (2) and
another clamp (3) as illustrated.
CAUTION:
• Make sure the control cable is attached to the flexible shaft properly.
Loose cable may catch the branches etc. and result in personal injury.
• Do not twine the control cable around the flexible shaft. Otherwise the throttle
may not work properly.

MOUNTING OF PROTECTOR

To meet the applicable safety provisions, only the tool/protector combinations as indicated in the table must be used.
CAUTION: The appropriate protector must always be
installed, for your own safety and in order to
comply with accident prevention regulations.
Operation of the equipment without the guard
being in place is not permitted.
Do not apply other combination when using
saw-blade.
NOTE: The standard combination of cutting tool differs from
county to country.
(1)
Metal blade
Protector for metal blade
Type A
Nylon cutting head
10
(2)
(1)
(3)
(2)
Type B
Protector for
nylon cutting head
Protector for
nylon cutting head