Tools And Accessories; Agitator Tool Variomix; Agitator Tool Promix; Supplementary Equuipment - Electrolux SMART Operating Instructions Manual

OPERATING INSTRUCTIONS | SMART LINE | BOILING PAN
17. TOOLS AND
ACCESSORIES

17.1 Agitator tool Variomix

Gate agitators are used to mash, mix or whip the
contents of the pan.
You can use the gate agitator with or without
scrapers.
The scrapers are used to avoid certain food pro-
duce sticking.

17.2 Agitator tool Promix

Promix propeller is used to pulp, mix or whip the
contents of the pan.
Bottom agitator is attached to the Promix agitator
to process light and /or smaller amounts of food
produce more efficiently.
The baffle plates are used to avoid splashes from
low-viscosity food.
17.3 Supplementary equipment and
accessories
17.3.1 Smart
Equipment
Measuring stick
17.3.2 Smart Variomix
Equipment
Gate agitator
Measuring stick
Bottom scraper
Side scraper
17.3.3 Smart Promix
Equipment
Propeller agitator
Bottom agitator
Baffle plate
Measuring stick
32
Accessories
Strainer plate
Cleaning brush, short
Cleaning brush, long
Accessories
Strainer plate
Cleaning tool
Bottom agitator
Whip tool
Cleaning brush, short
Cleaning brush, long
Accessories
Strainer plate
Cleaning tool
Cleaning brush, short
Cleaning brush, long
DOC.N
O
18. AGITATOR
MAINTENANCE
The agitator bearing is filled with grease from the
factory. Refilling grease should take place during in-
stallation and then at least twice per year.
Grease filling should be performed by trained
personnel.
• Use grease with high temperature properties*:
* Order Number:
• Grease should be pumped in so that it is forced
out through the overflow hole on the bearing
housing. Fig.4 pos.A.
Fig. 4
A. Overflow hole
• Check the grease that is forced out. If it shows
signs of being mixed with water, the agitator
bearing and seal should be removed for inspec-
tion and if necessary replaced.
18.1 If the pan with agitator is taken out
of service
For operation stoppages for periods longer than
one month:
• Pour in 2-3 litres of silicone oil to counteract the
desiccation of the agitator seals.
• Heat the pan to 60-80°C.
• Follow the instructions above.
Appropriate oil is e.g. Whiterex 309 (Mobil).
18.2 When the pan is put back into
service
• Pour off the oil and clean the pan.
: ST09184-02
ST8 00 24-00
A
EN | 02-2015