Webserver; Tcp; Snmp - PEAK COMMUNICATIONS TLTR3100 Installation And Operating Handbook

Installation and Operating Handbook
Figure 3.2: Configure IP settings window

3.3.1 Webserver

The webpage used to control the TLTR3100 unit is essentially split into two screens, Status and Configure. Each
one accessible via the links part way down the screen. The webpage is displayed by entering the TLTR3100
unit's IP address into a normal web browser. Figure 3.3 shows a typical web page view, note this may not
represent this particular unit.
Figure 3.3: Typical webpage status screen

3.3.2 TCP

The TLTR3100 unit can be controlled via TCP, this involves sending the normal RS232 / 485 commands to the
unit through a TCP port. The TCP port to be used is set by the user via one of the remote control interfaces.
The remote control protocol that can be used with the unit is shown in section 3.2.

3.3.3 SNMP

The TLTR3100 units can be controlled via SNMP via the built­in SNMP (Simple Network Management Protocol)
agent software. It supports SNMP Trap, RFC1155, 1157, 1212, 1213, 1901 & 1906, as well as the Peak MIBS.
The MIBS necessary for this are available from the Peak Communications website. Please refer to the Peak­
Agents.MIB file, as this shows which of the MIBS available are used for this TLTR3100 unit.
24 Peak Communications Ltd. TLTR3100