Canon Printing Using a Direct Camera/Printer Connection Guide Direct Print Connection Manual page 18

PictBridge Printing with Bubble Jet Printers
Setting the Printing Area (Trimming)
Please set [Paper Settings] first (p. 18) before setting the trimming settings. If the print
style is changed after having made trimming settings, you must select the settings
again.
1
Select [Trimming] and press the SET
button.
The trimming frame will appear at the center of the
image. If a trimming setting has already been selected
for the image, the frame will appear around the
previously selected portion.
The trimming setting screen differs depending on the camera model. Check which
of the following screens appear before selecting settings.
Steps 2a and 3a
2a
Trim the image.
Changing the Size of the Trimming Frame
Press the zoom lever or the zoom button to adjust the size of the trimming
frame.
The trimming frame can be changed to a minimum selection of approximately
half the displayed image or a maximum selection that is virtually the same size
as the image.
Expanding the trimming frame beyond its maximum size cancels the trimming
setting.
When printing an image that has been magnified using the trimming option,
the image quality may become coarser and grainier depending on the level of
magnification. If this happens, the trimming frame displays in red.
Moving the Trimming Frame
Move the trimming frame using the multicontroller or the up, down, right and
left buttons.
Rotating the Trimming Frame
You can rotate the trimming frame by pressing the DISP. button or the
DISPLAY button.
3a Press the SET button to close the setting menu.
Pressing the MENU button cancels the settings.
16
Trimming Frame
Steps 2b and 3b