the mechanism chassis).
shown below.
Note:
See the figure below for the phase matching between the
master cam and the cassette control drive gear.
insert
drive gear, aligning its wide tooth
the
to
master cam.
the hole on the
Figure l-43.
E ring (XRESJ40-06000)
Master Cam
Master Cam
REPLACEMENT OF LOADING
l
Removal
Remove 2 screws.
Figure l-44.
Replacement
l
@Take out the old loading motor. Place a replacement
loading motor as shown above (Figure l-44.).
Figure I-45.
Press-fit the loading motor pulley with a force of less than 98N
the motor.
M OTOR