Sharp VT-3448X Service Manual page 34

alignment with the line 1.3 mm left of the center line of the
sup guide shaft. Readjust as required in the following
steps.
Sup guide shaft
Make the adjustment with the
beginning of a E-180 tape.
Figure 1-I 5.
Figure l-1 6.
Put a bladed screwdriver into the tension pole ADJUSTER
and turn it clockwise.
Figure l-l 7.
Put a bladed screwdriver into the tension pole adjuster to turn
it counter-clockwise.
@Adjustable range of the tension pole ajuster.
@Adjustable range of tension pole adjusting cam.
Figure l-1 8.
Adjust the tension pole adjuster so that the circle mark on
the cam be within 90" left and right.
PLAYBACK BACK TENSION
l Remove the cassette housing control assembly.
l Make a short-circuit between TP7701 and TP7702,
both located at the right on your side on the main PWB.
Now plug in the AC cord.
pieces of vinyl tapes.
Weight to prevent
float (5009)
Figure
l Checking
within the set range 36.5 to 52 gem.
Notes:
guide.
end.
Tension pole adjusting cam
Cassette torque
meter
.