Page 3
Part 1: Spindle Part 2: Top rail Part 3: Botton Rail Part 4: Support Bean Part 5: Bracket Part 6: Right Side Rail Part 7: Left Side Rail Part 8: Feet Part 9 : Back Rail Part 10: Front Rail Part 11: Slats Part 12: Bottom Headboard Slat...
Page 5
Insert wooden dowels (E) into rails (9,10), dowels (H) into parts (4), insert dowels (F) into parts (5). Connect parts (9,10) to parts (7,6)
Page 6
Connect parts (9,10) to parts (6,7) With Bolt (A) for this use the Hex key (L) Secure parts(9,10) to parts (6,7) using screw (C) attach Feet (8) to frame parts (7,6) using screw (O) and Union Screw (P). Union Screw (P) Should be on the inside of the bed frame, with screw (O),on the outside of the leg.
Page 7
Secure feet to frame using screw(C). Attach the metal connector plate (S) to the 4 corners of the bed with screws (R). Take care to aligne the plate over the sean of the two parts, as shown in the drawing, before seguring in place. connect parts (5) and (3).
Page 8
Connect parts (2) to parts (4) using bolt (L) and hex key (D). Connect parts (5) to parts (4) using bolt (L) and hex key (D).
Page 9
Insert Spindles (1) in holes on part (3) Attach Spindles (1) in the part (2) using screw ( C )
Page 10
Insert Bottom Headbord Slat (12) and secure with Screw? Secure slat (11) Using Screw (B) and slat spacer (N)
Page 11
Attach base Headboard (5,3) on holes of the frame (9) using Bolt (I), washer (J), and nut (K) Tighten using both the hex key (l) and wrench(M)