Table of Contents
Advertisement
After Operation
Charging the Battery Pack
Important:
The battery pack is not fully charged
when you purchase it. Before using the tool for
the first time, place the battery pack in the charger
and charge it until the LED display indicates the
battery pack is fully charged. Read all safety
precautions.
Important:
Charge the battery pack only in
temperatures that are within the appropriate
range; refer to
Specifications (page
Note:
At any time, press the battery-charge-indicator
button on the battery pack to display the current
charge (LED indicators).
1.
Ensure that the vents on the battery and charger
are clear of any dust and debris.
Figure 16
1. Battery pack cavity
2. Battery pack venting areas 6. Handle
3. Battery pack terminals
4. Battery-charge-indicator
button
2.
Line up the cavity in the battery pack
with the tongue on the charger.
3.
Slide the battery pack into the charger until it is
fully seated
(Figure
4.
To remove the battery pack, slide the battery
backward out of the charger.
5.
Refer to the following table to interpret the LED
indicator light on the battery charger.
Indicator
Indicates
light
Off
No battery pack inserted
10).
5. LED indicators (current
charge)
7. Charger LED indicator
light
8. Charger venting areas
(Figure
16).
Green
Battery pack is charging
blinking
Green
Battery pack is charged
Red
Battery pack and/or battery charger is over or under
the appropriate temperature range
Red
Battery pack charging fault*
blinking
*Refer to
Troubleshooting (page 22)
information.
Important:
The battery can be left on the charger
for short periods between uses.
If the battery will not be used for longer periods,
remove the battery from the charger; refer to
Storage (page
Cleaning under the Machine
Service Interval: Before each use or daily
Cleaning under the Machine
Service Interval: After each use
For best results, clean under the machine soon after
you have completed mowing.
1.
Lower the machine to its lowest cutting-height
setting.
2.
Move the machine onto a paved level surface.
3.
With the motor running and the blade engaged,
spray a stream of water in front of the right, rear
wheel
(Figure
Note:
The water will splash into the path of the
blade, cleaning out the clippings.
g290533
16)
4.
When no more clippings come out, stop the
water and move the machine to a dry area.
5.
Run the motor for a few minutes to dry the
underside of the machine.
Cleaning under the Machine in the
Vertical-Stow Position
1.
Set the machine in the vertical-stow position;
refer to
Storing the Machine in the Vertical-Stow
Position (page
2.
Wash out the clippings from under the machine.
17
for more
21).
17).
Figure 17
18).
g002600
Advertisement
Table of Contents
