Operation
er the cooling water inlet on the lower
case or the cooling water pilot hole is
blocked. Consult your Yamaha dealer if
the problem cannot be located and cor-
rected.
Check that no water leaks from the joints be-
tween the exhaust cover, cylinder head, and
body cylinder.
EMU27670
Warming up engine
EMU35264
Electric start models
After the engine has started, warm the en-
gine up until the engine speed settles at
idling speed.
EMU36530
Checks after engine warm-up
EMU36540
Shifting
While tightly moored, and without applying
throttle, confirm that the engine shifts
smoothly into forward and reverse, and back
to neutral.
EMU31721
Stop switches
Confirm that turning the main switch to the
G
"
" (off) position stops the engine.
Confirm that removing the clip from the en-
G
gine shut-off switch stops the engine.
Confirm that the engine cannot be started
G
with the clip removed from the engine
66
shut-off switch.
EMU35880
Selecting outboard motor
After all engines have started, set all control
levers to Neutral. Push the engine selector
switch repeatedly to change the digital elec-
tronic control-active indicator and select the
desired engine.
ZMU05848
1. Port side control lever
2. Starboard side control lever
3. Port side engine
4. Center engine
5. Starboard side engine
1.
First, three engines can be operated.
TIP:
When all engines have started, the center
engine will run at the average speed of port
side and starboard side engines' speeds.
(triple engine)
1
P
C
S
3
4
5
2
ZMU05998