Yamaha F300 Owner's Manual page 70

Operation
start after 5 seconds of cranking, re-
turn the main switch to "
10 seconds, then crank the engine
again.
[ECM00192]
TIP:
The sub station can start and stop the en-
gine. However, it cannot operate the digital
electronic control.
EMU35762
Procedure for dual station models (sub
station)
EWM01840
WARNING
Failure to attached engine shut-off cord
G
could result in a runaway boat if opera-
tor is ejected. Attach the engine shut-
off cord to a secure place on your cloth-
ing, or your arm or leg while operating.
Do not attach the cord to clothing that
could tear loose. Do not route the cord
where it could become entangled, pre-
venting it from functioning.
Avoid accidentally pulling the cord dur-
G
ing normal operation. Loss of engine
power means the loss of most steering
control. Also, without engine power,
the boat could slow rapidly. This could
cause people and objects in the boat to
be thrown forward.
1. Turn the main switch of the main station
to " " (on) to make sure that the digital
electronic control-active indicator lights.
The engine can not be started when the
digital electronic control-alert indicator
lights.
2. Place the control lever in " " (neutral).
3. Push the station selector switch of the
sub station. Station change is only pos-
sible when all control levers have been
set to " " (neutral). Make sure that the
digital electronic control-active indicator
64
of the sub station lights.
" (on), wait
4. Attach the engine shut-off cord to a se-
cure place on your clothing, or your arm
or leg. Then install the clip on the other
end of the cord into the engine shut-off
switch.
ZMU05976
ZMU05995
ZMU05996