SEON SJ Series Installation Manual

Routine Maintenance
Most liquid cleaners or graffiti gel can be used to clean your camera enclosure.
Do not use abrasive cleaners that can scratch the polycarbonate dome and
reduce visibility of the camera.
If the polycarbonate dome in your camera is damaged or scratched beyond
use, order a replacement dome from your camera distributor.
Service and Warranty
If your SJ Series Dome Camera is to be returned to Seon Design for service,
please call toll free 1-877-630-7366, or 604-941-0880,
and/or serial number of your unit,
number. An RA number allows the Service Technicians to better track your
product when it comes in for service. Please show the RA number on the
outside of the package. ANY PRODUCT SENT TO SEON DESIGN
WITHOUTAN RA NUMBER MAY BE REFUSED.
Please refer to the Warranty form provided with your product to review the
terms of warranty service, contact and shipping information, as well as other
important issues regarding the service and operation of your product.
FCC Class B Statement (U.S.A.)
This device complies with Part 15
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Industry Canada Notice
This Class B digital apparatus meets all requirements of the
Interference-Causing Equipment Regulations.
Cet appareil numérique de la
Règlement sur la matériel brouilleur du Canada
Information in this guide is subject to change without prior notice.
© March 2007 Seon Design™ Inc.
All rights reserved. Printed in Canada
1
If the camera dome is damaged or
scratched, order a replacement dome
from your camera distributor.
2
Use the hex key supplied with the
camera to remove the locking screw.
Turn the bezel counter-clockwise to
unscrew it from the base.
3
Push the damaged dome out of the bezel.
Remove the old neoprene gasket from
the bezel.
4
Fit a new neoprene gasket over the new
dome and press the dome into the bezel.
5
Fit the bezel and dome onto the base. Turn
the bezel clockwise until it is snug. Use the
hex key to tighten the locking screw.
provide the model
and ask for a Return Authorization (RA)
of the FCC Rules . Operation is subject to
classe B respecte toutes les exigences du
.
www.seon.com
Document Part Number: 700-0049 R001
Replacing the Dome
SJ Series Dome Camera
Installation Guide
Canadian
Base
Dome
Gasket
Locking screw
Bezel