SEON SA Series Quick Installation Manual

Routine Maintenance

Most liquid cleaners or graffiti gel can be used to clean your camera
enclosure. Do not use abrasive cleaners that can scratch the window and
reduce visibility of the camera. If the window in your camera is damaged
or scratched beyond use, order a replacement window from your camera
distributor.

Service and Warranty

If your SA Series Wedge Camera is to be returned to Seon Design for
service, please call toll free 1-877-630-7366, or 604-941-0880, and provide
the model and/or serial number of your unit. Ask for a Return
Authorization (RA) number. An RA number allows the Service Technicians
to better track your product when it comes in for service. Please show the
RA number on the outside of the package.
DESIGN WITHOUT AN RA NUMBER MAY BE REFUSED
Warranty form provided with your product to review the terms of
warranty service, contact and shipping information, as well as other
important issues regarding the service and operation of your product.

FCC Class B Statement (U.S.A.)

This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.

Industry Canada Notice

This Class B digital apparatus meets all requirements of the Canadian
Interference-Causing Equipment Regulations.
Cet appareil numérique de la classe B respecte toutes les exigences du
Règlement sur la matériel brouilleur du Canada.
Information in this guide is subject to change without notice.
© June 2010 | Seon Design Inc. | All rights reserved.
www.seon.com Printed in Canada Part Number: 700-0004 R003
*700-0004*
1

Removing the Cover

1 Use the security key provided with your camera to remove the
screw that secures the cover to the base. See Figure 1.
2 Pull the cover away from the base. Do not twist the cover off.
3 Unplug the audio module harness from the connector on the
main circuit board.
Security
screw
Figure 1
ANY PRODUCT SENT TO SEON
. Please refer to the
Cover
Base
SA Series Wedge Camera
Quick Installation Guide
2

Changing the Window Bezel

The camera is factory assembled for wall mounting. For ceiling
mounting, swap the positions of the window bezel and the audio
module bezel. See Figure 2.
1 Use a Phillips screwdriver to remove the four bezel screws.
2 Exchange the audio module and window bezels. Install the
gasket between each bezel and the camera cover. Position the
anchor plate as shown in Figure 2.
3 Replace the four bezel screws. Do not use lock washers on the
anchor plate screws. Do not overtighten the screws.
Figure 2
Window bezel
Window
Window gasket
Bezel screws and lock
washers
Anchor plate
Audio module bezel