Table of Contents
Advertisement
Refer to Figure 6,Figure 7 to assemble stand. Use carriage
bolts (HP3) and flange nuts (HP9) throughout. Only hand-
tighten all fasteners at this time.
Make sure the two short support plates with extra holes (M)
are opposite one another as shown.
Slip rubber feet (L) onto ends of stand legs.
Place stand upright on level floor, and push down until it sits
evenly.
Tighten all nuts on stand assembly.
5.2 Assembly
If you notice any transport damage while unpacking, notify
your supplier immediately. Do not operate the machine!
Dispose of the packing in an environmentally friendly
manner.
Clean all rust protected surfaces with a mild solvent.
Prior to use, the following items have to be fitted:
Bandsaw table, Rip fence guide and Crank handle.
Fitting the table
Refer to Figure 8.
Loosen lock handle (shown in Figure 9) and pivot trunnion
(A1) to horizontal position.
Loosen lock knob (C2) and pull extension (C1) out from the
table (C).
Orient table as shown, then maneuver to allow saw
blade (A2) to pass through slot (C3) to the center.
Line up four threaded mounting holes underneath table with
the four mounting through-holes on trunnion.
Important: Adjust table so miter slot (C
saw blade (A
).
2
Secure with four M6x12 hex washer head screws (HP2).
Tighten with 13mm wrench.
Fitting Guide rail and fence
Attach guide rail (E, Figure 9) to front of table. Secure with
four wing screws (HP4) and flat washers (HP5).
) is parallel with
4
Fig. 8
Refer to Figure 10:
Place fence assembly (D, Figure 10) onto table at the miter
slot.
The rear hook should engage the rear of the table. The
fence body should engage the guide rail (E).
If the fence is not parallel to the miter slot:
Loosen two socket head cap screws (S1) with a 4mm hex
wrench. End cap (S2) may need to be removed.
Adjust fence so it is parallel to miter slot.
Lock the fence handle, securing it to the guide rail (E), and
verify that fence is still parallel to miter slot.
Retighten two screws (S1) to secure fence to the fence body
and replace end cap (S2).
Fence scale adjustment
Refer to Figure 10:
Place fence assembly (D) onto table (C) against the saw
blade. Lock fence.
If the hairline on the scale indicator does not point to zero:
Remove fence assembly (D).
Loosen screw (S3) that secures scale to guide rail (E).
Repeat step 1, then slide scale until hairline on scale
indicator points to zero.
8
Fig. 9
Fig. 10
Advertisement
Table of Contents
