Start-Up Software; Trigger And Return Readings - Keithley Integra 27 Series Quick Start Manual

Quick Start Guide

Start-up software

Models 2700, 2701, and 2750 – You can use the "Up & Running with TestPoint"
software (supplied on CD) to perform the following:
•
•
•
•
Model 2701 – A built-in web page is available to allow for easy Ethernet communi-
cation between the instrument and the computer. From this web page, you can
read and set network parameters and other data stored in the Model 2701. It also
takes readings and allows you to send command strings and receive data.
Using Internet Explorer (IE 5.0 or greater), a local intranet address is used to open
the web page. The web page address is the same as the IP Address of the Model
2701. Assuming the default IP Address is being used, the following intranet
address will open the web page: http://192.168.0.2
NOTE

Trigger and return readings

Remote programming – The following SCPI command sequence is used to trig-
ger a finite number of measurements and return the readings. It is assumed that
Factory defaults
INIT:CONT OFF
TRIG:COUN <n>
READ?
Included with each returned reading is a timestamp and a reading number (Read-
ing, Timestamp, Reading Number). For example:
1.00000000E+01VDC, +8694.16SECS, +6141RDNG#
The 10VDC reading is returned in exponent format. When the Model 27xx was
turned on, the timestamp and reading number started at zero. For the above
example, the measurement occurred 8,694.16 seconds after the unit was turned
on, and the reading was the 6,141
Control and configure the Integra instrument
Scan, acquire, and graph the data
Store data on disk for analysis
Save and recall instrument scan configurations
Details on using the Ethernet web page with the Model 2701 is pro-
vided in Section 10 (see "Internal web page") of the Model 2701
User's Manual.
have been previously restored.
' Disables continuous measurements. Measurements will not
' be performed until the instrument is triggered.
' Sets the trigger count: <n> = 1 to 9999. This specifies the
' number of measurements to be performed.
' Triggers measurement(s) and requests reading(s).
st
taken since the unit was turned on.
Integra Series 11