ADTRAN NetVanta 4660 Quick Start page 2

3. Provide power to the unit as appropriate. Refer to the
Installation Guide
4. Once the unit is powered up, open a VT100 terminal session using the following
settings: 9600 baud, 8 data bits, no parity bits, and 1 stop bit. Press <Enter> to
activate the AOS CLI.
5. Enter enable at the > prompt. Enter the enable password when prompted. The default
password is password.
You can also access the CLI from a Telnet or SSH client. In order to do this, you must know
the IP address of the AOS device. If you do not know the unit's IP address, you must use
the CONSOLE port to access the CLI. To access the CLI using a Telnet or SSH client,
follow these steps:
1. Connect the NetVanta unit to your PC using an Ethernet cable connected to the
GIG 0/2 Gigabit Ethernet port on the front of the device or connect the NetVanta unit
to an existing network that supports DHCP using the GIG 0/2 Gigabit Ethernet port on
the front of the device.
2. Open a Telnet or SSH client on your computer and enter 10.10.10.1. If your unit
received an IP address from a DHCP server or you have changed your unit's IP
address, you will need to enter that address.
3. For SSH, log into the unit using the default login (admin) and password (password).
For Telnet, only the default password (password) is required.
4. Enter enable at the > prompt and enter the enable password when prompted. The
default password is password.
C CLI C
OMMON
The following are common CLI commands and tips for getting started with the CLI.
Entering a question mark (?) shows contextual help and options. For example,
■
entering ? at the prompt will show all commands available from that prompt.
To view interface statistics, enter show interfaces <interface type> <interface
■
number>.
To view the current configuration, enter show running-config.
■
To view all the IP addresses currently configured, enter show ip interfaces brief.
■
To view the AOS version, serial number, and other information, enter show
■
version.
To view the routing table, enter show ip route.
■
To save the current configuration, enter write.
■
M
ANUALLY
g
NOTE
The configuration parameters used in the examples outlined in this document are for
instructional purposes only. Please replace all underlined entries (example) with your
specific parameters to configure your application.This step is unnecessary if the unit's IP
address has been configured automatically using DHCP.
2
at https://supportforums.adtran.com
OMMANDS
C
ONFIGURING THE
NetVanta 4660/5660 Hardware
for more details.
U ' IP A
NIT S DDRESS
617004660F1-13F