ADTRAN NetVanta 4660 Quick Start page 3

connection (EVC) (for a network-to-network interface (NNI)).The following steps assign an
IP address and subnet mask for the GIG 0/2.1 Gigabit Ethernet subinterface.
1. At the # prompt, enter config terminal.
2. At the (config)# prompt, enter interface gig 0/2.1 to access the configuration
parameters for the Gigabit Ethernet subinterface.
3. Enter ip address 192.168.1.1 255.255.255.0 to assign an IP address to the Ethernet
subinterface using a 24-bit subnet mask.
4. Enter exit to exit the Gigabit Ethernet subinterface commands and return to the
Global Configuration mode.
5. Enter ip route 0.0.0.0 0.0.0.0 192.168.1.254 to add a default route to the route table.
0.0.0.0 is the default route and the default subnet mask, and 192.168.1.254 is the
next-hop IP address to which the AOS unit should send all of its traffic. You will need
to enter the proper route, subnet mask, and gateway for your network. This
information is typically provided by an Internet service provider (ISP) or local network
administrator.
6. Enter do write memory to save the current configuration.
E T
NABLE ELNET
The following steps create a password of adtran for Telnet access. By default, Telnet
access is enabled with a password of password.
1. Verify that the prompt of your unit displays (config)#.
2. Enter line telnet 0 4 to change the configuration parameters for the Telnet sessions.
3. Enter login to require a password for Telnet access.
4. Enter password adtran to change the login password for the Telnet sessions.
5. Enter exit to return to the Global Configuration mode.
6. Verify that the prompt of your unit displays (config)#.
7. Enter do write memory to save the current configuration.
N V
ET ANTA
Feature
User Name
Password
Enable Password
HTTP Server
Event History
IP Routing
DHCP
Auto-Config
617004660F1-13G
U
SER
4660 D
EFAULTS
L A
OGIN CCESS
Default Value
admin
password
password
Disabled
Enabled
Enabled
Client Enabled
Zero Touch Provisioning Enabled
3