Crestron FlipTop FT2 Series Quick Start Manual page 7

FT2-1200-ELEC-PTL
FlipTop™ FT2 Series Cable Management System, 1200 Size, Electrical, Pass-Through Lid
6. Attach the side plate to the module by snapping the plastic clips on
the plate into the two slots on the module.
NOTE: When removing the side plate, use a flat-head screwdriver to
carefully pry the plastic clips off of the module near the two slots.
7. Feed the other end of the cable through an empty module slot in the
FT2 assembly.
8. Slide the pass-through cable module into the same module slot as
mentioned in the previous step. Use the guide ribs on the front and
rear of each module to help position the module in the FT2 assembly.
Install the Blank and Keystone Plate Module
Blank plate modules (sold separately) fill empty slots in module rows,
and keystone plate modules (sold separately) allow for cables
terminated with standard keystone jacks to be installed in the FT2
assembly. The blank and keystone modules each require one empty
module slot for installation.
To install a blank or keystone plate module into the
FT2-1200-ELEC-PTL:
Slide the blank plate module down into the appropriate module slot.
l
Use the guide ribs on the front and rear of each module to help
position it in the FT2 assembly.
For the keystone plate module, complete the following steps.
l
1. Snap the cable's keystone jack into the keystone opening in the
keystone plate module.
2. Feed the cable down through the empty module slot.
3. Slide the attached keystone plate module down into the same
module slot using the front and rear guide ribs to assist with
positioning.
Quick Start
7