HP 8163A Series Programming Manual page 39

Specific Command Summary
Command
:ZERO
[:SOURce[n]][:CHANnel[m]:]WAVelength:REFerence
:DISPlay
[:SOURce[n]][:CHANnel[m]:]WAVelength:SWEep
:CYCLes/?
:DWELl/?
:LLOGging/?
:MODE/?
:PMAX?
:REPeat/?
:SPEed/?
:STARt/?
:STOP/?
[:STATe]/?
[:SOURce[n]][:CHANnel[m]:]WAVelength:SWEep:STEP
:NEXT
:PREVious
[:WIDTh]/?
:SPECial
:REBoot
:STATus[n]
:PRESet
:STATus:OPERation
[:EVENt]?
[:EVENt]:LEVel1?
:CONDition?
:CONDition:LEVel1?
HP 8163A Lightwave Multimeter, HP 8164A Lightwave Measurement System,
& HP 8166A Lightwave Multichannel System User's Guide, E1299
Table 4 Specific Command Summary (continued)
Description
Exexutes a wavelength zero.
Sets the reference wavelength of a source to the val-
ue of the output wavelength.
Sets or returns the number of cycles.
Sets or returns the dwell time.
Switches lambda logging on or off or queries the
state of lambda logging.
Sets or returns the sweep mode.
Returns the highest permissible power for a wave-
length sweep.
Sets or returns the repeat mode.
Sets or returns the speed for continuous sweeping. 105
Sets or returns the start point of the sweep.
Sets or returns the end point of the sweep.
Stops, starts, pauses or continues a wavelength
sweep or returns the the state of a sweep.
Performs the next sweep step.
Performs the previous sweep step again.
Sets or returns the width of the sweep step.
Reboots the mainframe and all modules.
Presets all Enable Registers.
Returns the Operational Status Event Summary Reg-
ister.
Returns the Operational Status Event Summary Reg-
ister for slots 15 - 17 of the HP 8166A Lightwave
Multichannel System.
Returns the Operational Status Condition Summary
Register.
Returns the Operational Status Condition Summary
Register for slots 15 - 17 of the HP 8166A Light-
wave Multichannel System.
Specific Commands
Page
100
101
101
102
103
103
104
104
105
106
106
107
107
107
68
54
50
52
51
52
39