Measuring For Continuity - SATA 05221 Manual

Before you do in-circuit resistance measurement, make sure that the power of the circuit has been
disconnected and all the capacitors have been discharged.

Measuring for continuity

●
Insert the plug of the black test lead to the "COM" jack, the plug of the red test lead to
the " " jack.
●
Set the rotary switch to the "
●
Connect the test leads across the load to be tested.
●
When the resistance being measured is less than about 30Ω, the built-in buzzer will sound.
Note:
Before test, disconnect all power to the circuit to be tested and discharge all
capacitors thoroughly.
" position.
-17-
05221 Users Manual