Vivo STAND-SIT2E Instruction Manual

Electric sit-stand workstation

Electric Sit-Stand Workstation

Instruction Manual

SKU: STAND-SIT2E

Scan the QR code with your mobile device or follow the link

for helpful videos and specifications related to this product.

https://vivo-us.com/products/stand-sit2e

help@vivo-us.com

www.vivo-us.com

1-800-371-5654

Table of Contents

Need help?

Do you have a question about the STAND-SIT2E and is the answer not in the manual?

Page 1 Electric Sit-Stand Workstation Instruction Manual SKU: STAND-SIT2E Scan the QR code with your mobile device or follow the link for helpful videos and specifications related to this product. https://vivo-us.com/products/stand-sit2e help@vivo-us.com www.vivo-us.com 1-800-371-5654...
Page 2 WARNING! PACKAGE CONTENTS If you do not understand these directions, or if you have any doubts about the safety of the installation, please call a qualified technician. Check carefully to make sure there are no missing or defective parts. Improper installation may cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual.
Page 3 STEP 2 STEP 4 Insert power cord (F) at base of pole (A). Slide decorative cover (C) onto base of pole (A). Insert two screws (H) into the top 2 holes at the base of pole (A) using 4mm allen wrench (J) as shown in diagram.
Page 4 STEP 7 STEP 10 Tighten with 5mm allen wrench (K). Slide arm (D) onto pole (A) and tighten at desired height using 4mm allen wrench (J). STEP 8 OPTION A: Flat Back Monitor OPTION B: Curved Back Monitor STEP 11 For flat back monitors, attach VESA plates using For curved or recessed back monitors, use 16mm 12mm screws (M-A or M-B) with washers (M-E).
Page 5 Love your new VIVO setup and want to share? Tag us in your photo! @vivo_us If any parts are received damaged or defective, please contact us. We are happy to replace parts to ensure you have a fully functioning product.