Water Supplier And Drain - Technika DX6SS-6 User Manual

Water Supply and Drain
Cold water connection
Connect the cold water supply hose to a threaded 3/4 inch
connector and make sure that it is fastened tightly in place.
If the water pipes are new or have not been used for an
extended period of time, let the water run to make sure that
the water is clear. This precaution is needed to avoid the risk
of the water inlet to be blocked and damage the appliance.
Warning
The appliance is to be connected to the water mains using new hose sets and that old hose-
sets should not be reused.
About the safety supply
The safety supply hose consists of the double walls. The hose's system guarantees its
intervention by blocking the flow of water in case of the supply hose breaking and when the air
space between the supply hose itself and the outer corrugated hose is full of water.
Warning
A hose that attaches to a sink spray can burst if it is installed on the same water line as the
dishwasher. If your sink has one, it is recommended that the hose be disconnected and the
hole plugged.
How to connect the safety supply hose
1. Pull The safety supply hoses completely out from storage compartment located at rear of
dishwasher.
2. Tighten the connection of the safety supply hose to the faucet with thread 3/4 inch.
3. Turn water on and test for leaks before fully installing the dishwasher.
How to disconnect the safety supply hose
1. Turn off the water.
2. Unscrew the safety supply hose from the faucet.
INSTALLATION INSTRUCTIONS
PG 9