Starting A Cycle Wash; Changing The Program Mid-Cycle - Technika DX6SS-6 User Manual

Program Description
of Cycle
Wash(45℃)
Rapid
Rinse(50℃)
Note:
AS/NZS 2007.1: This program is the test cycle. The information for comparability test in
accordance with AS/NZS 2007.1.
ECO is the program recommended for a normally soiled load at rated capacity.
Starting A Wash Cycle
1. Draw out the lower and upper basket, load the dishes and push them back. It is
commended to load the lower basket first, then the upper one.
2. Pour in the detergent.
3. Insert the plug into the socket. The power supply refer to last page "Technical information".
Make sure that the water supply is turned on to full pressure.
4. Open the door, press the power button.
5. Choose a program, the indicator light will turn on. Then close the door, the dishwasher will
start its cycle.
6. At the end of the cycle, insure the water supply is turned off.

Changing The Program Mid-cycle

A wash cycle can only be changed if it has been running for a short time otherwise, the
detergent may have already been released and the dishwasher may have already drained the
wash water. If this is the case, the dishwasher needs to be reset and the detergent dispenser
must be refilled. To reset the dishwasher, follow the instructions below:
1. Press the Start/Pause button to pause the washing.
2. Press Program button more than three seconds the machine will be
program selection mode.
3. Press the Program button to select the desired progra
4. Press the Start/Pause button, the dishwasher will continued to run after 10 second
PROGRAMMING THE DISHWASHER
Detergent Running
Pre/Main Time(min)
25g
30
Energy Water
(Kwh) (L)
0.6 11.5
Rinse
Aid
PG 25