Digigram PYKO-in User Manual page 17

PYKO-in: Professional IP audio endpoint
- ​ G ateway TCP client​ : in this mode, PYKO establishes the TCP link with another PYKO
configured in server mode, and sends the serial data to the unicast or multicast address
defined in « ​ I P address ​ » and to the TCP port defined in « ​ C onnection port ​ » .
To enable the UDP mode, select « ​ G ateway UDP​ » for parameter «​ S erial link mode ​ » . PYKO
listens to the serial data it receives on the UDP port defined in « ​ C onnection port ​ » . The
parameter « ​ I P address ​ » must then be filled in case serial data are sent to a multicast
address.
PYKO can send serial data in UDP mode towards maximum 4 destinations. These
destinations are couples of « IP address / UDP port » defined in parameters « ​ D estination 1 ​ »
to «​ Destination 4​ » in section « ​ U DP transmission configuration​ ».
7.3.3.2. GPIO tunneling mode configuration
GPIO tunneling consists in transmitting GPI statuses of a PYKO to the GPOs of another
PYKO.
Its configuration can be done from section « ​ G PIO tunneling​ ».
17