Digigram PYKO-in User Manual page 11

In case you need to use PYKO-in an Icecast/Shoutcast encoder, the firmware to be used is
"PYKO-in Firmware shoutcast". The procedure to apply this firmware is as follows:
● Disconnect PYKO power supply cable.
● Connect the PYKO-in RS232 port to the computer COM port with a standard "null modem"
cable; hardware handshake is not required.
● From Command line, in update_rescue directory, type serial.bat COM1
● Adjust COM number according to your configuration.
● Reconnect PYKO power supply cable. Wait until upgrade is completed.
● PYKO is now in Shoutcast mode. Default IP address is 192.168.0.100.
6. MANAGING PYKO-IN
Depending on your needs, there are several ways of configuring and controlling PYKO-in.
PYKO-in: Professional IP audio endpoint
11