Safety caution Warning To avoid fire or electric hazards,never place your television receiver in an area with heavy moisture.Attention should be paid to avoid accidental scratches or impacts onto the LCD screen.The function of sound may be lost and the function may be disordered in electrostatic discharge ,they can be restored by operation of the controls.
Cleaning Unplug the television set when the LCD screen is to be cleaned.Use soft fabrics for cleaning the screen and electric cables.If necessary, a piece of wet but clean soft cloth can be used for cleaning the screen,but never use any liquid or spray detergent.
Specification 1、 Power equipment This product requires AC power supply. The voltage value is as per the information specified on the rating label,which is fixed on the back of the television set. 2、 Power consumption The power consumption is less than 160 watt which is marked on the back cover.
Cautions and Notes Caution: 1、 Don’t close the power supply when the TV set is on,because it may short the life-span of TV. 2、 Before welding PCB turn off the power first, otherwise it may cause short circuit. 3、 Adjustment must be done with correct instructions NOTE: 1、...
daylight lamp or other equipment which transmits infrared.To solve this problem you can move the TV set away from the equipment. 8、 If the screen displays a static picture for a long time,the screen will still maintain the static picture if you turn to another channel.This is decided by the characteristic of liquid crystal.
Factory menu Factory menu options 1. To enter factory menu you can follow the steps: A.Press “MENU”, and the main menu will display on the screen. B.Press “DISPLAY” three times continuously, and a red “M” will display on the top-left corner of the screen. 2.
adjust the parameters manually. D. Brightness and contrast numerical value range adjusting. Video_Bri_MAX Video_Bri_MID Video_Bri_MIN Video_Con_MAX Video_Con_MID Video_Con_MIN HDTV_Bri_MAX HDTV_Bri_MID HDTB_Bri_MIN HDTV_ Con _MAX HDTV_ Con _MID HDTV_ Con _MIN PC_Bri_MAX PC _Bri_MID PC _Bri_MIN PC _ Con _MAX PC _ Con _MID PC _ Con _MIN E.
channel directly, no stand-by. 1: When AC power on, the TV set will be stand-by state. If you press “Power”(DC power on), it will start up to “TV” channel. 2: The TV set will store the current source channel before power down. When AC power on, it will start up to the source channel stored directly, no stand-by.
Volume 50 Volume 75 Volume 100 K. ADC GM5221 ADC Phase Delay ADC Phase CLK Note:There is two separate group parameters you can change: TV/AV/Svideo/USB and HDTV. Two group parameters are saved separately. Press “TV/AV” to switch beween the two groups. - 12 -...
Trouble shooting guide This diagram is suitable to elementary trouble shooting,if you want further service,please contact us. Black Screen Power module Idicator is normal? is nomal? Backlight Check Replace open? Main power board module 24V of Power module is ok? Replace power module...